UModeler X MCPリリース — AIエージェントでモデリング
UModeler X

Copy Deltas Tool

The Copy Deltas tool copies the vertex movement of another blend shape, or of another frame of the same shape, into the edited frame — replacing or adding, at any strength, to all or only the selected vertices.

Translation in progress — showing the English version.

The Copy Deltas Tool copies the vertex movement (position deltas) of another blend shape — or of another frame of the same shape — into the edited frame. Use it to start a new expression from an existing one, to combine two shapes, or to take over only part of a shape.

▣ Image
Copy Deltas tool panel: Source Shape, Source Frame, Mode, Strength, Selected Vertices Only, the Copy Deltas button and the line showing how many vertices will change

How to use

  1. In the shape list, click the shape to copy into, and its frame in the frame list.

  2. Launch the Copy Deltas tool.

  3. Pick the Source Shape and, for a shape with several frames, the Source Frame.

  4. Set Mode and Strength. To copy only part of the shape, turn on Selected Vertices Only and select vertices in the Scene view.

  5. Check the line under the button — N vertices will change — and press Copy Deltas.

▣ Image
Before and after: a new Smile_Wide shape made by copying Smile at Strength 1 in Replace mode, then adding MouthOpen at Strength 0.5 in Add mode

Options

OptionDescription
Source ShapeThe shape to copy from. It starts on the first shape other than the edited one.
Source FrameThe frame of the source shape, listed as Frame N (weight). Available when the source shape has more than one frame. When you pick a source shape, it starts on the same frame number as the edited frame.
ModeReplace — the edited frame becomes the source movement × Strength. Over the whole frame, vertices the source does not move are set back to 0. Add — the source movement × Strength is added to the current movement.
StrengthMultiplier for the copied movement. Default 1. Use 0.5 for half, or a negative value for the opposite direction.
Selected Vertices OnlyCopies only to the selected vertices. Default off.
Copy DeltasApplies the copy.

Notes

  • The source and the target must differ. Copying a frame onto itself shows Pick a different shape or frame to copy from.
  • With Selected Vertices Only on and nothing selected, the panel shows Select vertices to copy to.
  • Normals and tangents are not copied. In the area that changes, custom normals are reset and calculated from the new shape.
  • When the weight is between frames, Copy Deltas first adds a frame at that weight, in the same undo step.

See also — Edit Group · Scale Deltas Tool · Shape Transfer Tool

Copy Deltas Tool | UModeler X Manual